After the motor was in I installed the trans 3 in drop crossmember from Trans Dapt with an energy suspension mount. I also cut some 1/4in plates to mount between the frame and the mounting flanges to allow for easier install and removes. Sorry no pictures of that for some reason. I then set up my steering column and linkage using the parts recommended by nolimit. I used a Ididit column with a double D shaft and joints from Flaming river. I had to notch the frame and boxing plate and it is very close to the A arm. I may have to grind the A arm a little for clearance when I get the alignment set on the truck.
I also set the bed in place to check the fitment of the fuel cell and had to modify the rear cross brace under the bed as it was directly over the pump and filler.
And that is where am at now. I am getting ready to start hanging the front sheet metal back on so I can get the wheel clearance issues worked out then start mocking up the engine including a turbo.