The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 55.2-59 Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force?

autowrench · 10-02-2023, 11:10 PM

Yes, the kit is complete. I know because there were 2 complete disc brake setups and I needed to sort them out and figure which was which. One is the heavier duty caliper and slightly bigger rotor. I figured out it was for converting an original straight axle to disc brakes and 5x4.75" wheel. I will sell that off some day. I'm planning on using all of the suspension parts from the kit to go with the bolt in if I do go that way.

10-02-2023, 11:10 PM	#26
autowrench Registered User Join Date: May 2022 Location: Trout Creek, Montana Posts: 65	Re: Has anybody here used a Chassis Engineering bolt-in crossmember on a Task Force? Yes, the kit is complete. I know because there were 2 complete disc brake setups and I needed to sort them out and figure which was which. One is the heavier duty caliper and slightly bigger rotor. I figured out it was for converting an original straight axle to disc brakes and 5x4.75" wheel. I will sell that off some day. I'm planning on using all of the suspension parts from the kit to go with the bolt in if I do go that way.