Re: Transmission-bell housing question
Quote:
Originally Posted by '68OrangeSunshine
My measurements were done in the field, not out of a book.
Does the post-'68 Saginaw have the larger 5-1/8" diameter?
|
I have also measured the bell in the "field"(with dial calipers)..... I run a 66 truck bell on my longhorn, fitted with a Richmond 6 speed(car style bearing retainer, & 26 spline input shaft), & it all fits the early truck bell The 68 up saginaws(truck), do have the 5 1/8" bearing retainer, but the retainer can be swapped tween the car or truck sag 3 spds, as well as the sag 4 spd. Im not sure what plastic pc is broken tho? L
__________________
69 longhorn,4" chop,3/5 drop, 1/2 ton suspension/disc brakes,1 1/2" body drop,steel tilt clip, 5.3/Edelbrock rpm intake/600 carb, Hooker streetrod shorties,2 1/2" exhaust/ H pipe/50's Flows , 6 spd Richmond trans,12 bolt/ 3.40 gears....
Last edited by crazy longhorn; 06-18-2007 at 10:20 AM.
|