[jbjburbs]

OK, now back to the burb. To be honest, I haven't done much to it other than work on some templates for sheet metal in the rear. I haven't moved to metal as I'm dragging my feet on a fuel cell and that could impact the floor layout.

I moved the front bag mount some from inside the frame to outside (almost centered with fitting on outside). This setup should leave room for a shock inside the upper control arms yet keeping a good turning radius. If my numbers are right I'm looking at 4in ride height with 30" combo with full turn. Keeping the bag close to the frame will still get good lift, too.

I don't have pics of the front, but I'll snap some once the new plates are tacked.