Thread: The Brown Turd
View Single Post
Old 03-27-2020, 08:03 PM   #88
Thebrownturd
Registered User
 
Join Date: Jun 2013
Location: Northern Nevada
Posts: 233
Re: The Brown Turd

Its been a while so here is the what I've been working on lately.

Winter 18-19:
I pulled out the transmission and attempted a rebuild in my dad's garage. It went fairly well other than being super cold but, that is what insulated catharrt bibs were invented for.
I cleaned and painted the housing. All of the clutched inside the tranny were toast and it was only a matter of time before there was nothing left. Not to mention, I had found out that a few large chunks of metal casting had come off of the shift rod where it contacts the pawl, near the spring end, and had been floating around the tranny for some time.
I pulled a bunch of funky work done on the valve body and reset everything back to stock configuration minus a shift kit. I ended up needing to buy a new drum/input shaft since a chunk of that metal got stuck behind a thrust washer and chewed a bunch of the bearing surface off the drum.
Attached Images
     

Last edited by Thebrownturd; 03-27-2020 at 09:51 PM.
Thebrownturd is offline   Reply With Quote