[Ontcalimo]

I went to their Corona California factory today and saw their seats in person. They don't have a showroom, but they have friendly representatives (non-high pressure sales guys)that can show you their seats without hesitation, even if it's close to their lunch time. They rolled one of their 67-72 C10 bucket seats for me, which converted to an office seat. The rep showed me at least three types of vinyls they can use, and gave me some samples to keep. I like a particular vinyl that looked like actual leather. The vinyl did look like real leather. The seats were overall comfortable, more on the firm side. I like the fact they had good lateral support, but probably not ideal for an extra large big person. I can not speak about their bench seats though. But the craftsmanship is excellent. The seat can be adjusted to be pulled back, but this would be limited in a truck obviously. They also make dashboards, which are a full dash that fills up to windshield. They also make sun visors. You can select the color type on the stitch. I just purchased the visors and dashboard made with leather like vinyal at this time. I would say their prices are on a little bit on the pricy side, but still accessible and reasonable for an average person. I think it's still a lot cheaper than going to an upholster that custom makes interiors. I am undecided whether I am going to buy the seats or bench seat at this time, but probably will purchase the buckets seats . I like the fact they have door panels that fill over from top to bottom of doors, and they have center console too. But I'm not to fond of style of the door panel for the 67-72 C10 line. This is just my opinion. I think others would disagree. I wish they had a more plain sporty look (with exceptions of their seats. However, their sets give it a very custom look, I think it would impress anyone.