[tantrumpipeline]

running 20x8.5 338's, cheap wheels to buy and the machining on the rotors cost me $40, pretty minor and could have been ground at home with a common grinder and patience, lots of pics in my build thread probably the last page or 2 just got the front rolling but here are 3 to give you the idea, this was not all machined to fit just to match the factory taper on the rotor, all you need is the top 1/4inch or so needs to be ground for them to fit. The general consensus is the coys are far better quality but the customer service is awful, to me you get what you pay for, my 338's look really good but the caps don't fit too easy I wrecked 2 being rammy, I'm cheap so the 338 was my only option. Truck is just a chassis but I'm running 2.5 western drop spindles and 3 in cpp drop springs out front 7 in drop rear and plan on a 2.5in spacer out back