[superchevy]

I used the DIY crossmember and it did not fit well...when I bolted it to the frame, it pulled the frame rails in...moving the engine mounts in by a 1/4"...I actually had to get the hot-wrench out and heat up the center of the crossmember, then use a porta-power to "spread" the frame rails back out to where they should be...stretching the crossmember at the same time.
I also installed a 2" body lift. I had to "clearance" the firewall for the HEI and tall valvecovers...as it is, I have about a 1/4" of clearance between the valvecovers and the firewall...I figure they will "self-clearance" when I get on the 468. I had to notch the frame a lot to clear the Corvette manifolds...so much so on the pass side, that I had to box it in with 1/4" plate to stiifen that part of the frame..(really wanted run those manifolds, lol).
Note: I did not move the drivetrain forward. I should have. Would have given more clearance all the way around.
Here are some pics