[dug224]

Finally found some time to work on the truck. Got the rear Envoy body mounts tacked to the frame. I first bolted them to the body and then lowered on to the frame and tacked with the stick welder. Was going to use the MIG since I had been practicing with it but I ran out of gas.

Disassembled the front sheetmetal so I could get to the front mounts that had to be cut off the frame. Got the drivers side cut off and will move it around to line up with the factory body location. You can see where I cut the mount and you can see where the bolt is that it has to meet. Will have to trim the end that mounts to the frame slightly. Will have to trim the rounded in as well. It hits the body.