Quote:
Originally Posted by rockyrivermark
listen... I haven't even started to remove the shaft yet just asking the question so easy on the criticism on my skill set. I was guessing I would have to remove the U-joints but again just asked in case there is a easier way. This is the first 2 piece I've worked on.
I will be sending out the front portion of the shaft to a local shop be cut and balanced.
I got the info I needed. thanks randy400
thanks
RRM
|
I tried to be as polite as possible, I just had to take it for the info I had..... and what I got out of it sounded a little scary..... for all I know your a nuke welder and master fabricator and can do this in your sleep.
Good Luck and post pics.