The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Center drive shaft bearing or one piece drive shaft??

Peanut74 · 02-09-2022, 08:10 PM

Thanks for the input guys. I have been getting an education on this matter. I have removed the center bearing carrier bracket since I won't be using it. From what I understand I should be ok since I'm not doing a big drop.

I should have stated that I changed the truck from LWB to SWB and its currently at standard ride height. If I do drop it I will probably do a 2/4 to close up the wheel opening gap.

02-09-2022, 08:10 PM	#14
Peanut74 Registered User Join Date: May 2018 Location: Prattville, AL Posts: 590	Re: Center drive shaft bearing or one piece drive shaft?? Thanks for the input guys. I have been getting an education on this matter. I have removed the center bearing carrier bracket since I won't be using it. From what I understand I should be ok since I'm not doing a big drop. I should have stated that I changed the truck from LWB to SWB and its currently at standard ride height. If I do drop it I will probably do a 2/4 to close up the wheel opening gap. __________________ -------------------------------------------------------- 1967 C10 "Snowball" (Currently in a million pieces down from a bazillion) 1989 Toyota DLX pickup "The Hulk" 2012 Jeep JKU "Crush" 1976 Chevy short bed with a 327 and 3 on the tree (Sold it to buy the Blazer) 1971 Chevy Blazer (Sold it)