The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**aotte1** · 03-10-2018, 03:42 AM

Coating the suspension parts and e-brake handle. Using as a place to hang wet coated parts, our K10 frame that is waiting for the body panels to be painted for ever. Used a cold ceramic coating on these parts, that do not fit in a oven. You need to be familiar with safety/health requirements when using ceramic coatings. Use it when a very hard, durable, and good corrosion protection coating is needed. Also requires special material preparation, followed by immediate coating application in low humidity. The applied coating is a very thin layer, using specific air pressure, gun tip size, and one pass.

03-10-2018, 03:42 AM	#25
aotte1 Senior Member Join Date: Oct 2013 Location: lousiville Ky Posts: 2,637	Re: C10 Short Bed Fleetside V8 Automatic Coating the suspension parts and e-brake handle. Using as a place to hang wet coated parts, our K10 frame that is waiting for the body panels to be painted for ever. Used a cold ceramic coating on these parts, that do not fit in a oven. You need to be familiar with safety/health requirements when using ceramic coatings. Use it when a very hard, durable, and good corrosion protection coating is needed. Also requires special material preparation, followed by immediate coating application in low humidity. The applied coating is a very thin layer, using specific air pressure, gun tip size, and one pass. Attached Images Last edited by aotte1; 03-10-2018 at 10:07 PM.