The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 01-16-2012, 10:44 PM

i would like to try to rework my orginal hinges to make them work. but i just dont see how i could..i still need to trim the inners a little bit more, and its already super close to the lower bolt hole, unless i cut it off...has anyone tried that?

im sanding down my interior now since i cant figure out whether to do my own body work or let someone else do it. since i lost my heater, and am not using the heater control panel (for now), is everyone welding them up or leaving the dummy control panel in there to fill the gap?

i just about have the dash sanded up and will prob move to the back and start sanding later this week..

01-16-2012, 10:44 PM	#559
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,134	Re: Project 67 DRGNWGN - 67 Burban!! i would like to try to rework my orginal hinges to make them work. but i just dont see how i could..i still need to trim the inners a little bit more, and its already super close to the lower bolt hole, unless i cut it off...has anyone tried that? im sanding down my interior now since i cant figure out whether to do my own body work or let someone else do it. since i lost my heater, and am not using the heater control panel (for now), is everyone welding them up or leaving the dummy control panel in there to fill the gap? i just about have the dash sanded up and will prob move to the back and start sanding later this week.. __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_]