The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project "Ghost of Poseidon" - 1972 C10 Pro-touring

siggyfreud · 08-20-2020, 09:51 PM

Did some welding and exhaust work today, along with some 3D printing. I cut the back half of the exhaust off some time ago because I didn't like it. I replaced the mufflers with a couple of BORLA units, but didn't run any tailpipes for awhile. Decided to rectify that.

I got some carbon tips, and then 3D printed some trim rings for them. I need to up the outside diameter slightly to fill the gap fully, but this gives you an idea of how it'll look.

No trim ring:

Trim ring (a little too small but close):

08-20-2020, 09:51 PM	#90
siggyfreud Registered User Join Date: Jun 2012 Location: Portland Posts: 1,330	Re: Project "Ghost" - 1972 C10 Pro-touring Did some welding and exhaust work today, along with some 3D printing. I cut the back half of the exhaust off some time ago because I didn't like it. I replaced the mufflers with a couple of BORLA units, but didn't run any tailpipes for awhile. Decided to rectify that. I got some carbon tips, and then 3D printed some trim rings for them. I need to up the outside diameter slightly to fill the gap fully, but this gives you an idea of how it'll look. No trim ring: Trim ring (a little too small but close): __________________ Current Build - Project "Ghost of Poseidon" 72 C10 Pro-touring build Previous Build - 66 GMC Pro-touring build. Sold.