[FirstOwner69]

When I installed a Vortec crate engine with a Holley in my 69 CST/20, I opted to go with the Lokar switch. I made a very simple bracket for the rear carb stud out of 1" angle aluminum and polished it to enhance the appearance. I then attached the Lokar cable bracket to my new bracket. It all works fine.

The Pontiac switch looks promising depending on the bracket. If you'd like, I can make a tracing of the original switch bracket. It might be a starting point for a bracket for the Pontiac switch.

Here are some pics of my original installed and the Lokar installation. Highlighting on the first picture was for a previous thread. The wire from the Lokar switch to the transmission is not installed in the pic.