Re: 59 Apache - Lifelong obsession
I'm been working on mocking up my transmission crossmember. I'm using a kit from Welder Series that will let me unbolt the middle so the transmission could be dropped out without pulling the engine. I plan to weld the outer tubes to the Angle Iron and weld or bolt the angle iron to the frame.
The thing that I need to figure out is my exhaust. I would like to maintain as much ground clearance as possible. If possible I would like to run the exhaust above the transmission crossmember. I am wondering if I could sneak a pipe between the master cylinder and the transmission if I put a heat shield on the master? Has anyone else done this?
__________________
My Build Thread: 59 Apache - Lifelong obsession
http://67-72chevytrucks.com/vboard/showthread.php?t=622133"]59 Apache - Lifelong obsession
|