The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 15" mags with 2-1/2" drop spindles?

Greasey Harley · 07-18-2020, 01:30 AM

I guess, a 1/3 drop is as low as I'm willing to go.
I could go lower in the front, but then, the back would look too high,
I can't lower the back any more, and haul motorcycles. I think I'm pushing it as is.
There's only about 2-1/2" to the bump stops, the way it sets now.
I WILL NOT notch the frame, so this is how it will set.

-1" CPP front springs
-2" Cpp Rear springs
1" drop blocks from board member: Way2Lo2
1/3 Static drop.

07-18-2020, 01:30 AM	#4
Greasey Harley Registered User Join Date: May 2013 Location: Post Falls, ID Posts: 884	Re: 15" mags with 2-1/2" drop spindles? I guess, a 1/3 drop is as low as I'm willing to go. I could go lower in the front, but then, the back would look too high, I can't lower the back any more, and haul motorcycles. I think I'm pushing it as is. There's only about 2-1/2" to the bump stops, the way it sets now. I WILL NOT notch the frame, so this is how it will set. -1" CPP front springs -2" Cpp Rear springs 1" drop blocks from board member: Way2Lo2 1/3 Static drop.