View Single Post
Old 01-18-2013, 05:18 PM   #33
29od1
Senior Member
 
Join Date: Oct 2006
Location: Wichita, Kansas
Posts: 1,050
Re: Original Bucket seats installation????

Thanks for the response Roger. So it looks like 1-1/4" over is where it really should be. I agree that your bracket would fit with no mods if you drill the drivers side outer front bolt hole at 1-1/4" over from the existing bench seat bolt (that's measured center to center).

I used a short drill bit and put a bolt through the z-shaped cab support. Maybe it's not exactly factory, but since the nut's there I thought I'd use it.

It would be nice to have a second reference point if anyone else with an original bucket seat truck could measure like Roger did above.
29od1 is offline   Reply With Quote