This might be the last update before LST...
Last night was a good night in the shop. We got a lot accomplished.
Engine, trans, and drive shaft are all in and bolted down. Shift linkage is hooked up, the engine wiring is hooked up less the MAF and the two Oxygen sensors. Need to install water pump and fan, the alternator and bracket, the belt, install the trans dip stick and a new pan gasket, and add all the fluids. I should be able to fire it up this afternoon. IF that goes well, then put on the front clip, drive around the block to check it out and then load it up for LST...
Again Korbin and Owen where out there helping the old man out, Owen has school and two baseball games today, so he headed to bed about 10:30 last night, Korbin stayed out with me till about midnight, and I called it quits at 1am. I had to come to work for 1/2 a day today.
Here are pics from last night. I meant to get some of the parts used to mate up the TH350, but I forgot...
Sloppy Style engine stand modifications. Turns out it did not need this much clearance, but it worked out..
Finished up the harness that goes to the Temp Sender and Oil Sender for the dash lights and to the starter...Purple wire to the starter, block plug to the Temp Sensor, and the blue wire to the Oil Pressure Sender.
Shortly before I called it a night. I added the plug wires after this pic and the alternator and bracket are not bolted in yet, its just to mock up...
Look at this forecast for the LST weekend. I can't wait!
