View Single Post
Old 06-07-2018, 12:18 PM   #1
dmjlambert
Senior Member
 
dmjlambert's Avatar
 
Join Date: Apr 2016
Location: Cypress, TX
Posts: 3,572
Thinking about TH400 kickdown

I have a 1969 CST/10 with 350 and quadrajet. I am thinking about the choices for TH400 kickdown. I rigged up a hand held switch to my transmission and took the truck for a ride to see if my kickdown worked and if I like what it does for the drivability of the truck, and decided I would like to go ahead and hook it up.

For a 1969 truck, it was a carburetor mounted switch like this. I don't have my switch or switch bracket any more, although somewhere in a box I still have the throttle linkage paddle. The switch is flat out not made any more, although I have seen new brackets with throttle linkage paddle for $45. A rusty used bracket and switch like this in untested condition is typically listed on eBay for about $300.
Name:  th400 kickdown switch and bracket.jpg
Views: 1196
Size:  13.6 KB

For aftermarket switches there are Lokar and B&M switch kits. I don't care too much for these, but I suppose they get the job done.
Name:  afterm.jpg
Views: 953
Size:  14.5 KB

There are also micro switches and brackets typically used for nitrous.
Name:  nitr.jpg
Views: 964
Size:  4.9 KB

There are pedal lever mounted ones that go in the cab for later model trucks that use a throttle cable. This would not work for my truck unless I figured out a way to mount it with a fabricated bracket in the engine compartment.
Name:  pedal.JPG
Views: 1019
Size:  9.9 KB

I am thinking about one of these (below), as it looks really close to the stock design. When I wrote to the vendor and asked about it, they said they didn't have any pictures of it installed, and it is for Pontiacs. They weren't car guys I guess, they were just selling crap on eBay so didn't want to discuss how it might work on a Chevy truck. They are $44.
Name:  44.jpg
Views: 887
Size:  5.8 KB

What do you guys think about these Pontiac fabricated new switch assemblies and the likelihood they would work on my truck? If it won't work, I suppose if I need to I could get the bracket shown in the top picture, and the switch and bracket for Pontiac shown in the bottom picture, and saw off the part of the bracket that has the bolt hole and glue or fasten it to the original style bracket, so I would have the angled metal and hole that holds the switch, and have the right bolt hole mount for the carburetor. I'm considering the options now and interested in opinions.

Or if somebody here on the forum has the fabricating skills to help me out with a stock-like bracket that can hold a micro switch at the right spot, that would be great. If anybody can offer that, then this can be a want-to-buy post.
dmjlambert is offline   Reply With Quote