Started to take both the blazer and the truck apart a few days ago....didnt find any real suprizes other than the front crossmember in the blazer was in wrong....luckily it was only bolted in with 3-3/8ths bolts.
Used the measurements from the truck(engine trans and front sheetmetal off) and set it in the correct spot,drilled and bolted it up.
Since this is planned to be my lo-budget pimpin II project Im planning on re-using as much stuff off of the 72 LB C10 as possible.... Ill start taking some pics and do a build thread for you guys in the next few days.....
