Re: Boyd Welding-67-72 Rear Mount Aluminum Tank
Wouldn't that side fill need to be a little lower for bedfloor clearance? Or is that assuming you are leaving the side brackets where they are and not the additional 3/4"
Dave Boyd....
If I do the side fill on mine, have the side flange 3/4 higher so the tank fits flush, and take 1" off the bottom, would that change the pricing at all?
Also, any chance of me paying today or tomorrow to get mine produced as soon as you have time? I am ready for my tank as soon as I can get it.
Mine is carb setup...not EFI...
__________________
Looking for a 67-72 swb or blazer project in or around VA.
Last edited by VA72C10; 10-13-2009 at 10:45 AM.
|