The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - 68 GMC 4x4 chassis being built to be a 70 4x4!

Mikey72 · 02-21-2011, 10:45 PM

I have a 72 4x4 that was converted into a short bed but when they cut the frame they cut it in front of the rear cab mounts. So when i pulled the bed apart to replace the floor i noticed that on the drivers side the cab mount has been welded to the frame and it sits about 1/2 inch higher than the passenger which is only held on by two bolts that they drilled in. I'm wondering if you know the measurements for how high up the rear cab mount sits from the bottom of the frame to the bottom of the mount. Ive been looking around but havent founf anything yet. If you could help me out with this it would be awesome. Thanks again.

Mikey

02-21-2011, 10:45 PM	#60
Mikey72 Registered User Join Date: Sep 2010 Location: havelock, n.c. Posts: 19	Re: 68 GMC 4x4 chassis being built to be a 70 4x4! I have a 72 4x4 that was converted into a short bed but when they cut the frame they cut it in front of the rear cab mounts. So when i pulled the bed apart to replace the floor i noticed that on the drivers side the cab mount has been welded to the frame and it sits about 1/2 inch higher than the passenger which is only held on by two bolts that they drilled in. I'm wondering if you know the measurements for how high up the rear cab mount sits from the bottom of the frame to the bottom of the mount. Ive been looking around but havent founf anything yet. If you could help me out with this it would be awesome. Thanks again. Mikey __________________ Big_Mac ( )(_.)(._)( ) ( ) \___/ ( )