Re: Whose on Steelies? Post 'em up!
Quote:
Originally Posted by NC67Chev
To 67 C-30 (or anyone else that can advise),
I was planning on posting a question about using original steel wheels after I complete my power disc brake conversion and 2.5/4 drop. It seems like the people on this post likely hold the answer to my question, so I'll just post here. I've found some 15" 6 lug disc wheels that will enable me to use my original hubcaps. However, I've read a couple of posts that seem to say that there is an issue with control arm clearance with 15" wheels after a 2.5" spindle drop. Is this the case? If so, how did you get around it?
Thanks!
|
To answer your question about 'interference', there is some but it varies w/the back-spacing. Narrower wheels require less trimming of the lip around the BJ edge of the lower a-arm; wider wheels w/more back-space might require more.
Hop over to the suspension forum & post up your wheel size & back-space. See if someone might have that combo to give you a more specific answer.
__________________
67SWB-B.B.RetroRod
64SWB-Recycle
89CCDually-Driver/Tow Truck
99CCSWB Driver
All Fleetsides
@rattlecankustoms in IG
Building a small, high rpm engine with the perfect bore, stroke and rod ratio is very impressive.
It's like a highly skilled Morrocan sword fighter with a Damascus Steel Scimitar.....
Cubic inches is like Indiana Jones with a cheap pistol.
|