Quote:
Originally Posted by BAM55
I agree 100%
You got 2 choices filler over epoxy or filler over bare metal if you are taking it down to bare metal. Once epoxy is covering everything that can rust, then you can move on to your fill printers. I use slicksand and its nice but unnecessary if you don't need that high of a build, its like sprayable filler (but it will not hurt anything to use it) the epoxy will act as your rust protection. Once you get to high fill primer its time to guide coat and block this is where the work comes into bodywork.
|
Full marks! 100% correct!
A good epoxy primer covered with a good quality high build urethane primer is perfect for this job.