The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Later model 6-hole ralley wheels and Isuzu caps

Brad · 12-27-2005, 03:34 PM

Years ago I had these 6-hole ralley wheels and someone on hear suggested using Isuzu Trooper hubcaps. I did this and happened to have some aftermarket spinners that I mounted up as well. You could also use 4" dome/wide angle mirrors and glue them on. Once you get the Isuzu caps, all you have to do is cut off the 6 extensions that go into the holes of the Isuzu rim. This could be done with a hacksaw or Dremel and then just mount them up on the Chevy rims. You can see the finished product below.

I just thought I'd share this with those that have the 6 hole ralley wheels or are thinking about going this route.

12-27-2005, 03:34 PM	#1
Brad Out of the carpool lane. Join Date: Jan 2000 Location: Clark Co, WA Posts: 5,673	Later model 6-hole ralley wheels and Isuzu caps Years ago I had these 6-hole ralley wheels and someone on hear suggested using Isuzu Trooper hubcaps. I did this and happened to have some aftermarket spinners that I mounted up as well. You could also use 4" dome/wide angle mirrors and glue them on. Once you get the Isuzu caps, all you have to do is cut off the 6 extensions that go into the holes of the Isuzu rim. This could be done with a hacksaw or Dremel and then just mount them up on the Chevy rims. You can see the finished product below. I just thought I'd share this with those that have the 6 hole ralley wheels or are thinking about going this route. Attached Images __________________ 1968 C-10 SWB, 5.7 Vortec/700R4/3.73 posi, Torch Red 1968 Camaro, 250/Powerglide, all original (No, I'm not gonna drop a 350 in it!...Jeez!) 2000 Honda VFR in the faster yellow! 2008 Husqvarna TE-610 1967 C-10 SWB 'Six Appeal'-Gone but not forgotten...