The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - PROJECT "Father/Son" C-20 Rolling Chassis Build

**ChiefRocka** · 10-09-2007, 01:26 AM

The last few for tonight.....
-

-
I built this jig to hold the pads at correct spacing.....I will place the degree finder on the tubing, and record the measurement. So I can set it up when I transfer the whole thing to the 14-bolt.
-

-

-
I might weld a 'jigger' to the track bar mount, and transfer at the same time...but then again I might not....
-

-
-
-
See ya....

10-09-2007, 01:26 AM	#102
ChiefRocka Hollister, CA. Join Date: Sep 2006 Location: Hollister, Ca. Posts: 6,147	Re: PROJECT "Father/Son" C-20 Rolling Chassis Build The last few for tonight..... - - I built this jig to hold the pads at correct spacing.....I will place the degree finder on the tubing, and record the measurement. So I can set it up when I transfer the whole thing to the 14-bolt. - - - I might weld a 'jigger' to the track bar mount, and transfer at the same time...but then again I might not.... - - - - See ya.... __________________ John What the Heck is that ?? CURRENT BUILDS: 62 BurbMaster Other Builds: My '63 C-10,LWB,CC,BBW '06 HD StrAight Axle Swap Father/Son '67 C-20, LQ9,4L80,Bagged,8-Lugger !!Good Friend Richard's Build AMERICAN CUSTOMS & CLASSICS (831) 630-1965 www.ACCHOLLISTER.com ACC on FACEBOOK "Rest in Peace, Mom & Dad ... I will see you again someday!" Last edited by ChiefRocka; 10-09-2007 at 01:27 AM.