[Madkidd007]

So I already was thinking I’d trim the burb floor flush with the factory left to right support and stitch weld it to keep it from moving at all. Then tie the front to back truck floor supports to the burb support, lastly I was going to trim the truck floor flush with the burb support, then use vertical sheet metal to fill in the gaps. Sitting on the couch it dawned on me I shouldn’t have started trimming the burb floor yet, so I went in the garage and proceeding to do the following. Use a piece of straight square steel and fold the sheet metal over. Now I’ll just buy the truck floor to it and trim the height. Then weld. So stronger floor support than a stock rear burb floor and the seam will be under the seat. Also the outer three inches or so I’m overlapping the truck floor over the outter edge of the burb support to make sure I’m perfectly level and centered. Tomorrow I’ll hopefully get all the trimming done and come forward a few more inches and be done with the back for a while