Well not a lot going on the last couple of weeks. I have been putting off blocking the cab out cause well sanding sucks
I started blocking out the rear the other day and found a problem area that will need some attention. Looks like the area on the right side of the cab right above where my brother welded the patch in warped as it is bowed in. I don't know how I missed it but I did. Now I have to get the stud welder out and pull it some. I have also been working on putting some walls up in my garage so that I can paint in there over the winter without having to worry about where the overspray goes. I used 1x2" studs and wrapped heavy mil plastic around it. I then used duct tape to tape up all the seams and painters tape to tape the top and bottoms.