Quote:
Originally Posted by Palf70Step
There was factory wiring for a trailer brake controller. Normally it is just stuff under dash and you add the appropriate connector for your brake controller. You could just zip tie or tape that up under the dash like the factor did.
https://www.youtube.com/watch?v=nf9bHdmwf2M |
I'll watch that youtube, but I found a few holes drilled in the HVAC vent that shoots air at drivers feet. I think that was were a brake controller was mounted. I still don't understand the need for an aftermarket controller when this truck came factory with one. I understand some will say they aren't as good and maybe that's the case.....I don't have enough experience with that, especially with this truck. A buddy has a 2015 3/4 ton pickup and he hauls a dump trailer with brakes and says his works great.
Hole in dash unexplained still, likely a toggle but for what....there's holes in the cargo area, that I think maybe they had a permanent mounted cooler, so maybe they had that on toggle. Those wires should be somewhere if so. That is still a guess at best.