Re: Jeep J10
My son and I pulled the seat and floor covering out of the cab today to see what we’re dealing with. Just a little rust on the drivers floor! There was the classic fix of a piece of sheet metal laying over the floor and duct taped into place but the rust had gone beyond the patch. Several thick floor mats were on top but you had to be careful or else your feet would go thru the floor! Pass side is better but still has a few holes. We ordered patch panels and will get these fixed up.
Also ordered a gallon of Lizard Skin ceramic insulation and a couple of boxes of Dynamat to insulate the cab nicely one we get it patched up.
Then we stripped the wire harness off the new motor - need to figure out where to get it stripped down to a stand-alone harness.
|