View Single Post
Old 03-04-2007, 11:33 PM   #3
Rokcrln
Senior Member
 
Rokcrln's Avatar
 
Join Date: Jul 2005
Location: Winters Ca. 95694
Posts: 4,843
Re: LFD's low buck truck build!

I use 2" painter tape for laying out large cuts like this. Just put the tape on nice and flat and it will follow the body lines then place the next piece right up to the edge of the first one. Repeat this 2 more times and you will end up with just under 8" ( I guess the tape is a hair under 2"). I used a 4" cut off wheel that is 1/16" thick. Now when you start your cut just keep the blade right along the out side edge of the tape. The more carefull you are here the faster the next few steps will be. I found it was easier to first cut the inside first then the out side. Once you have cut it all apart then remove the bed bolts, unhook the wiring and lift it off.

Kevin
LFD Inc.
Attached Images
     
Rokcrln is offline