The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

PBFAB.COM · 04-10-2007, 12:35 AM

A few more... I tacked up the two edges on the fenders and will fire up the TIG welder tomorrow and make em one piece.

You can see in the previous pics where I have marked all the cuts with tape... my finger is also pointing to the lower edge of the hood where it folds over and is pinch welded... it is important to remove this edge on the hood piece and the fender piece.

04-10-2007, 12:35 AM	#22
PBFAB.COM Senior Member Join Date: Dec 2003 Location: Mesa,Az Posts: 3,981	Re: West Coast 67 A few more... I tacked up the two edges on the fenders and will fire up the TIG welder tomorrow and make em one piece. You can see in the previous pics where I have marked all the cuts with tape... my finger is also pointing to the lower edge of the hood where it folds over and is pinch welded... it is important to remove this edge on the hood piece and the fender piece. Attached Images __________________ www.PorterbuiltFabrication.com Phone: 480-297-2621 E-mail: sales@pbfab.com Find us on FaceBook under Porterbuilt Fabrication Specializing in Chassis and Suspension Components for your Classic Chevrolet Truck. We offer components from the following manufacturers: Porterbuilt Accuair Ridetech (Air Ride Technologies) Air Lift Wilwood Intro Unisteer ECE Gotta Show Air Lift Borgeson CPP Supporting this forum since 2003!