View Single Post
Old 08-25-2020, 06:31 PM   #16
68PanelTruck
Registered User
 
68PanelTruck's Avatar
 
Join Date: Aug 2020
Location: Frankfort, Ill
Posts: 143
Re: Need advice on rust issues on a 68 Panel

Quote:
Originally Posted by richard2717 View Post
You are correct, you will need tall hump blazer floor if running the 4 speed. I am running a car 4 speed so it was not needed. GMC Pauls is where I got mine and they were great to deal with. I checked the Suburban support this morning after I found it and it is totally different than the panel cross member. it is way shorter where it is further back on the frame.
Thanks again for checking that out for me. I guess I'll keep looking for a used one in good condition. Same for the rear doors sill.
68PanelTruck is offline   Reply With Quote