The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs...

Frizzle Fry · 05-15-2012, 12:21 AM

Update

Well, between the 6x12 schedule and having family in town on my one week off, I managed to sneak out to the shop for a few...

Continued on the exhaust (yes, that is a home-made macebell on the right).

Resonating-Wave-Termination-Tuned-Pulsificator-Assemblage

The collector is 2.5" and the termination chamber's outlet is 3" (will neck back down to 2.5"

You may have noticed the the trans supported by a jack. Yes, I had to hack half of the trans x-member off to do this, but I have a plan

Plates are electro-polished stainless:

The guy that does all my work for me

Bottom welded up:

Internal stand-offs to support the flats:

I need to close up those two gaps, neck it back down from 3" to 2.5" with a collector flange, and install the O2 sensor bung. But here's how it sits right now:

05-15-2012, 12:21 AM	#1254
Frizzle Fry Registered User Join Date: Aug 2005 Location: Hillsboro Oregon Posts: 6,449	Re: '66 Sunbeam Minx Project - F20C/6sp/4-link/Discs... Update Well, between the 6x12 schedule and having family in town on my one week off, I managed to sneak out to the shop for a few... Continued on the exhaust (yes, that is a home-made macebell on the right). Resonating-Wave-Termination-Tuned-Pulsificator-Assemblage The collector is 2.5" and the termination chamber's outlet is 3" (will neck back down to 2.5" You may have noticed the the trans supported by a jack. Yes, I had to hack half of the trans x-member off to do this, but I have a plan Plates are electro-polished stainless: The guy that does all my work for me Bottom welded up: Internal stand-offs to support the flats: I need to close up those two gaps, neck it back down from 3" to 2.5" with a collector flange, and install the O2 sensor bung. But here's how it sits right now: