The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

**kwmech** · 10-15-2019, 10:59 AM

Pull the nose of the diff out of the housing and clamp the yoke in a vice.

You'll probably have to use a puller to get the yoke off as the factory puts sealer on the splines to prevent leakage. Also have to be careful going back together with the crush sleeve if you are using it over. OR pull the nose out and take it somewhere where they know what they are doing

10-15-2019, 10:59 AM	#9
kwmech Senior Member Join Date: Mar 2003 Location: Colfax-California Posts: 8,391	Re: Pinion nut won't move. Pull the nose of the diff out of the housing and clamp the yoke in a vice. You'll probably have to use a puller to get the yoke off as the factory puts sealer on the splines to prevent leakage. Also have to be careful going back together with the crush sleeve if you are using it over. OR pull the nose out and take it somewhere where they know what they are doing Last edited by kwmech; 10-15-2019 at 11:05 AM.