Re: budget beater c10 to k30 swap over build.
so today i start final assembly . started bolting stuff on the frame for good .
then i got the trans and 203/205 doubler all buttoned up and ready to be set in today . wow i had a lot left to finalize on it than i had figured .
had to lengthen and readjust the shift linkage on the tripple shifter setup since i moved the mount farther forward .
had to swap the front output seal from the std size to the special size for the np208 pass drop front output flange swap size . you use a timken 473457 seal then a np208 pass side drop front c/v 4 bolt flange unit on the swapped in 32 spline front output . makes it all work together nice and good . my used c/v flange i got used and and a bit of seal area wear so i got a timken kwk99187 speedi repair sleeve . also used red locktight on the speedi sleeve .
but i am ready to drop this part and the engine back in the frame for good .
__________________
77-k30lb BIG truck build .
87-k30lb budget beater build .
85-k30lb the plow machine build .
85-c10sb summer fun toy .
-----------------------------
HOLLEY SNIPER efi = worst case of p.i.t.a i ever had .
EDELBROCK pro flo 4 = best deal going so far . love my setup works great.
|