[Mulk]

Here's the hinges.

After getting the Hinges into the body, I tied them together with a section of 1x1 tubing to keep them aligned, and tacked everything into place.

I had to make the pockets for the door. The ones with the kit were too shallow. So I used some 2x4 box tube I had around, and fabbed them up. Once I got thos tacked into place, and made sure everything was still aligned, i also tied those together with a section of 1x1 angle iron.

The door is solid, with no "sag" whatsoever, and stays put when closed. Once I figure out interior, I deal with covering that lower door pocket.