The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

howell57 · 05-11-2019, 07:03 PM

I've got some clean up as far as fuel lines not needed and and a plate to cover up all the holes when I took all the AC/heater stuff out.
I put the motor mounts on so the engine sits forward as much as possible. My measurements say I might not have to modify trans hump???
Trying to figure out ignition wiring to marry old with new. Can't find a constant hot wire with key in the RUN position, so I ordered a switch and push button start. Engine will be totally on its own electrical system with a couple security mods.

05-11-2019, 07:03 PM	#41
howell57 Registered User Join Date: Sep 2018 Location: Redding, Calif. Posts: 101	Re: Greyghost 1971 C10 l83/6l80E Build I've got some clean up as far as fuel lines not needed and and a plate to cover up all the holes when I took all the AC/heater stuff out. I put the motor mounts on so the engine sits forward as much as possible. My measurements say I might not have to modify trans hump??? Trying to figure out ignition wiring to marry old with new. Can't find a constant hot wire with key in the RUN position, so I ordered a switch and push button start. Engine will be totally on its own electrical system with a couple security mods.