I see that you used CPP tubular engine frame mounts but what adaptor plates did you use on the block? Are those Poly motor mounts? Compared to stock location, where does the engine site? Forward, back, higher, lower? How far off the firewall. And last and not least. Howd you squeeze the A/c pump in there? Are you going to have enough room to run the lines? Or are you going to have to do some frame trimming? I am at this point in my build and want to pull the trigger on parts but still dont know what the correct combination of parts are to make it all work. Any and all info is much appreciated. Keep up the awesome work!!!!!!
