Re: Converting coil style ignition to HEI........what is involved?
Hi, I can't tell you what your old wires were for, but when I installed a new wiring harness from hotrodwires, one wire was dedicated as the Hot wire to go to the BAT side of the dist cap, the other terminal was for Tach. In essence, a full 12 volt source needs to go to the dist. I suppose your dist will be grounded via the engine and engine to chassis. So with a test light you could locate your hot wire, which should show 12 volts on a VOM.
I'm sure someone with much more knowledge than I will chime in soon; )
Dne'
Posted via Mobile Device
Last edited by Denee007; 03-12-2013 at 08:46 AM.
Reason: Spell
|