[Bluerust]

I pulled apart the rear leafs and blasted and painted them. Replaced the press in eye bushings and plastic pads. Blasted and painted the frame and started assembling and mocking up.

The exhaust on this project was a little tricky, I piped it a few times... Ive also heard complaints that 6.0 engines are noisy and drone so with that in mind I was aiming for quiet. I picked up a set of speed engineering c-10 long tubes which fit perfectly other than needing 2 spark plug wires clearance adjusted with a hammer, a set of magnaflow hiflow cats, some flex joints, a knock off magnaflow- xlerator muffler, and a vibrant performance resonator