Re: 71 350 Rebuild advice needed - Head and Cam Suggestions
Quote:
Originally Posted by 72SB
OP
you are absolutely going to want to get new lifters for any new cam. Use Valvoline VR1 or Joe Gibbs break in oil as they have a high zinc content.
Those heads are not great candidates for going 2:02/1:60 valves but at a minimum get hardened exhaust seats, and a complete valve job
A mild cam in the 218/224 range or even smaller.
I know you are set on that motor but IMHO a later year 1 piece RMS full hydraulic roller cam with vortech heads would, be what I would have done
IMHO even with a cam, that motor will be in the 275ish HP range unless you get a more modern head. Heads and cam should be a compatible package. One without the other really leaves a lot of HP on the table
|
Any chance the heads would do ok with a bit smaller valves than the 2.02/160 you recommend or is that the only bigger step up. I'll have to call summit to see what they'd recommend for an aluminum head and cam I guess. I've heard they are good to chat with?
__________________
1971 Chev C10 - 250ci L6 w/3 speed on the floor
Upgrades: Power Steering
3 Core Radiator
7 Hole Gauge Cluster
Power Brakes (Incoming!!..)
1971 350 (Incoming!!..)
|