Installed the passenger side door skin today!
Getting it ready
IMAG1538 by
jarrod vanwinkle, on Flickr
I bought a skin zipper I don't what happened. I only used it for about a 3 minutes and it got super hot and started melting? Step 1 worked but I could not get step two too work. I had to hammer and dolly it the rest of the way flat. I don't know if it was the zipper or the dolly but I creased the bottom of the door.
IMAG1540 by
jarrod vanwinkle, on Flickr
IMAG1541 by
jarrod vanwinkle, on Flickr
IMAG1539 by
jarrod vanwinkle, on Flickr
I did a fitment test on the door. Everything is good except the very front lower corner it scrapes when the door is opened.
IMAG1542 by
jarrod vanwinkle, on Flickr
IMAG1545 by
jarrod vanwinkle, on Flickr
IMAG1546 by
jarrod vanwinkle, on Flickr
IMAG1547 by
jarrod vanwinkle, on Flickr
Should I weld this tab on the door skin to the inner door? It's the piece under the vent window.
IMAG1548 by
jarrod vanwinkle, on Flickr
Random painted parts.
IMAG1550 by
jarrod vanwinkle, on Flickr