The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post - Project 67 DRGNWGN

**kev2809** · 11-28-2009, 07:08 PM

got it all welded up today. started grinding down the welds with a flap disc but im starting to run out of light. gonna finish it up in the morning and hopefully spray a can of primer on it then lay some filler next week.

since the new piece is a little more boxier than what it should be, i had to pie cut both sides, shape it to match, and weld it up. this left a little indention a little less than 1/4", so im gonna have to address this later. im gonna try to pull it out some before i start laying filler.

i found this interesting....i noticed a few spots of filler the previous owner had put on , so i stripped it down and found this. looks like a bullet hole, lol. there is 2 more spots like this so im gonna see if theres anymore.

11-28-2009, 07:08 PM	#54
kev2809 low n' slo Join Date: Mar 2009 Location: rosenberg, texas Posts: 5,133	Re: Project 67 DRGNWGN - 67 Burban!! got it all welded up today. started grinding down the welds with a flap disc but im starting to run out of light. gonna finish it up in the morning and hopefully spray a can of primer on it then lay some filler next week. since the new piece is a little more boxier than what it should be, i had to pie cut both sides, shape it to match, and weld it up. this left a little indention a little less than 1/4", so im gonna have to address this later. im gonna try to pull it out some before i start laying filler. i found this interesting....i noticed a few spots of filler the previous owner had put on , so i stripped it down and found this. looks like a bullet hole, lol. there is 2 more spots like this so im gonna see if theres anymore. __________________ 67 1/2 ton Suburban - Project DRGNWGN. Build thread -_--_--_ _________ _--_-_ -/____\|__\|__\__ ,.,,,.,.,,.,\|_O _______ O_] Last edited by kev2809; 11-28-2009 at 07:09 PM.