Quote:
Originally Posted by Dave
It'll be done tomorrow. Just PM the address to me and I'll send it you.
|
beat me to it!
I checked mine this morning and I thought it was .030" - .031" which would be about 22ga.. I'll double check that.. it's carbon steel and rough dimensions I took are same, about 1.25" x 2.25".. pinion cover bolt is .500" so clearance hole maybe slightly larger, lock washer didn't leave clean hole on mine to be precise but never see it after installed
Les is also looking for a couple per post #11, could you make them for him too please? I don't mind making some but you'll certainly be done before me
thank you!