|
Re: Blazer cargo area floor swap - old floor removal tips
I took mine out in pieces b/c I needed to reuse the cross silles and at the time didn't have the right tool to do it any other way. Started at the rear and cut up to the first cross member, then cut across to expose spot welds, then drilled them out, separated the floor and cut across then the second set of spot welds were exposed drill and repeat down the cargo area
Shear that cuts a pig tail and a angle grinder required
__________________
Semper Fi...Uncle Sam, you da man
All parts offered to help are free, unless otherwise noted
Dont try this stuff in my build thread, unless you have 55 years of mechanical OTJ training
SAFETY FIRST
AS usual, off topic
They say your mind goes second, can't remember the first
Jim
|