The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Spf79 · 02-27-2018, 05:41 PM

I think you can get away without one... Although it would not hurt to get one.
Personally I would shim it if you have it apart. Make sure to run metal shims, I think mine were $45 and change to my doorstep. I can't remember what degree of shim I used for a 5" overall lift, so you may have to do a little bit of researching to figure that one out.

Good luck!

02-27-2018, 05:41 PM	#2
Spf79 Registered User Join Date: Jun 2016 Location: Vancouver, Washington Posts: 422	Re: axle shim,3" lift? I think you can get away without one... Although it would not hurt to get one. Personally I would shim it if you have it apart. Make sure to run metal shims, I think mine were $45 and change to my doorstep. I can't remember what degree of shim I used for a 5" overall lift, so you may have to do a little bit of researching to figure that one out. Good luck! __________________ Full top blazer or bust....