[Madkidd007]

Well just a quick snap of my mounts. The frame stands were off a square body, as well as the entire crossmember and suspension. I sliced the original 1st gen mounts and slid the engine down/rubber mount side up. Then just simply welded it up. One of these days I’m going to redo them. The plan is to take square steel and cut it diagonally at the same angle of the current mount and then drill holes to mount it to the block and rubber pads. It’ll be the same thing I have now just not welded together

Side note that notch was to clear my power steering lines, that is till I realized I notched the wrong side. That’s what I get for doing both at the same time.