The 1947 - Present Chevrolet & GMC Truck Message Board Network - View Single Post

Ruscal · 06-23-2018, 05:09 PM

My memory is a little foggy about that job. I thought the shaft was attached to the clutch pedal, and the brake was on a spline or similar. Or it could have been the other way. I got it out of there, replaced the bushings and modified the pedal attachment by adding a bolt or threads somehow. I don't recall why. I added adjustable clutch pedal stops at the top and floor so my hydraulic throw out bearing would not over travel. I would suggest just going at it and see if there is room to pull the shaft. I may have had to remove my '67 hand brake lever for access?
Russ

06-23-2018, 05:09 PM	#3
Ruscal Registered User Join Date: Jun 2013 Location: Carlsbad, California Posts: 165	Re: Rebuild hanging pedal assy My memory is a little foggy about that job. I thought the shaft was attached to the clutch pedal, and the brake was on a spline or similar. Or it could have been the other way. I got it out of there, replaced the bushings and modified the pedal attachment by adding a bolt or threads somehow. I don't recall why. I added adjustable clutch pedal stops at the top and floor so my hydraulic throw out bearing would not over travel. I would suggest just going at it and see if there is room to pull the shaft. I may have had to remove my '67 hand brake lever for access? Russ __________________ RC